Drylines are atmospheric boundaries separating dry from moist air that can initiate convection. Potential changes in the location, frequency, and characteristics of drylines in future climates are unknown. This study applies a multi-parametric algorithm to objectively identify and characterize the dryline in North America using convection-permitting regional climate model simulations with 4-km horizontal grid spacing for 13-years under a historical and a pseudo-global warming climate projection by the end of the century. The dryline identification is successfully achieved with a set of standardized algorithm parameters across the lee side of the Rocky Mountains from the Canadian Rockies to the Sierra Madres in Mexico. The dryline is present 27% of the days at 00 UTC between April and September in the current climate, with a mean humidity gradient magnitude of 0.16 g−1 kg−1 km−1. The seasonal cycle of drylines peak around April and May in the southern Plains, and in June and July in the northern Plains. In the future climate, the magnitude and frequency of drylines increase 5% and 13%, correspondingly, with a stronger intensification southward. Future drylines strengthen during their peak intensity in the afternoon in the Southern U.S. and Northeast Mexico. Drylines also show increasing intensities in the morning with future magnitudes that are comparable to peak intensities found in the afternoon in the historical climate. Furthermore, an extension of the seasonality of intense drylines could produce end-of-summer drylines that are as strong as mid-summer drylines in the current climate. This might affect the seasonality and the diurnal cycle of convective activity in future climates, challenging weather forecasting and agricultural planning.

Abstract The collection efficiency of a typical precipitation gauge-shield configuration decreases with increasing wind speed, with a high scatter for a given wind speed. The high scatter in the collection efficiency for a given wind speed arises in part from the variability in the characteristics of falling snow and atmospheric turbulence. This study uses weighing gauge data collected at the Marshall Field Site near Boulder, Colorado, during the WMO Solid Precipitation Intercomparison Experiment (SPICE). Particle diameter and fall speed data from a laser disdrometer were used to show that the scatter in the collection efficiency can be reduced by considering the fall speed of solid precipitation particles. The collection efficiency was divided into two classes depending on the measured mean-event particle fall speed during precipitation events. Slower-falling particles were associated with a lower collection efficiency. A new transfer function (i.e., the relationship between collection efficiency and other meteorological variables, such as wind speed or air temperature) that includes the fall speed of the hydrometeors was developed. The root-mean-square error of the adjusted precipitation with the new transfer function with respect to a weighing gauge placed in a double fence intercomparison reference was lower than using previously developed transfer functions that only consider wind speed and air temperature. This shows that the measured fall speed of solid precipitation with a laser disdrometer accounts for a large amount of the observed scatter in weighing gauge collection efficiency.

Abstract Accurate snowfall measurement is challenging because it depends on the precipitation gauge used, meteorological conditions, and the precipitation microphysics. Upstream of weighing gauges, the flow field is disturbed by the gauge and any shielding used usually creates an updraft, which deflects solid precipitation from falling in the gauge, resulting in significant undercatch. Wind shields are often used with weighing gauges to reduce this updraft, and transfer functions are required to adjust the snowfall measurements to consider gauge undercatch. Using these functions reduces the bias in precipitation measurement but not the root-mean-square error (RMSE). In this study, the accuracy of the Hotplate precipitation gauge was compared to standard unshielded and shielded weighing gauges collected during the WMO Solid Precipitation Intercomparison Experiment program. The analysis performed in this study shows that the Hotplate precipitation gauge bias after wind correction is near zero and similar to wind corrected weighing gauges. The RMSE of the Hotplate precipitation gauge measurements is lower than weighing gauges (with or without an Alter shield) for wind speeds up to 5 m s −1 , the wind speed limit at which sufficient data were available. This study shows that the Hotplate precipitation gauge measurement has a low bias and RMSE due to its aerodynamic shape, making its performance mostly independent of the type of solid precipitation.

Convection-permitting models (CPM) with at least 4 km horizontal grid spacing enable the cumulus parameterization to be switched off and thus simulate convective processes more realistically than coarse resolution models. This study investigates if a North American scale CPM can reproduce the observed warm season precipitation diurnal cycle on a climate scale. Potential changes in the precipitation diurnal cycle characteristics at the end of the twenty first century are also investigated using the pseudo global warming approach under a high-end anthropogenic emission scenario (RCP8.5). Simulations are performed with the Advanced Research Weather Research and Forecasting (ARW-WRF) model with 4-km horizontal grid spacing. Results from the WRF historical run (2001–2013) are evaluated against hourly precipitation from 2903 weather stations and a gridded hourly precipitation product in the U.S. The magnitude and timing of the diurnal cycle peak are realistically simulated in most of the U.S. and southern Canada. The model also captures the transition from afternoon precipitation peaks eastward of the Rocky Mountains to night peaks in the central U.S., which is related to propagating mesoscale convective systems. However, the historical climate simulation does not capture the observed early morning peaks in the central U.S. and overestimates the magnitude of the diurnal precipitation peak in the southeast region. In the simulation of the future climate, both the precipitation amount of the diurnal cycle and precipitation intensity increase throughout the domain, along with an increase in precipitation frequency in the northern region of the domain in May. These increases indicate a clear intensification of the hydrologic cycle during the warm season with potential impacts on future water resources, agriculture, and flooding.

Abstract. Transfer functions are generally used to adjust for the wind-induced undercatch of solid precipitation measurements. These functions are derived based on the variation of the collection efficiency with wind speed for a particular type of gauge, either using field experiments or based on numerical simulation. Most studies use the wind speed alone, while others also include surface air temperature and/or precipitation type to try to reduce the scatter of the residuals at a given wind speed. In this study, we propose the use of the measured precipitation intensity to improve the effectiveness of the transfer function. This is achieved by applying optimized curve fitting to field measurements from the Marshall field-test site (CO, USA). The use of a non-gradient optimization algorithm ensures optimal binning of experimental data according to the parameter under test. The results reveal that using precipitation intensity as an explanatory variable significantly reduce the scatter of the residuals. The scatter reduction as indicated by the Root Mean Square Error (RMSE) is confirmed by the analysis of the recent quality controlled data from the WMO/SPICE campaign, showing that this approach can be applied to a variety of locations and catching-type gauges. We demonstrate the physical basis of the relationship between the collection efficiency and the measured precipitation intensity, due to the correlation of large particles with high intensities, by conducting a Computational Fluid-Dynamics (CFD) simulation. We use a Reynolds Averaged Navier-Stokes SST k-ω model coupled with a Lagrangian particle-tracking model. Results validate the hypothesis of using the measured precipitation intensity as a key parameter to improve the correction of wind-induced undercatch. Findings have the potential to improve operational measurements since no additional instrument other than a wind sensor is required to apply the correction. This improves the accuracy of precipitation measurements without the additional cost of ancillary instruments such as particle counters.